Automatic transmissions Allison 3000 and 4000 Series with electronic control Gen4
Show 102550100 entriesSearch:
ERROR CODE | DESCRIPTION | LAMP CHECK TRANS | REACTION CONTROL SYSTEM |
---|---|---|---|
C1312 | Low voltage signal to the inclusion of retarder | Off. | Retarder is not included |
C1313 | High voltage signal at the inclusion of retarder | Off. | Retarder is not included |
P0122 | Intermittent or low level signal accelerator pedal position | Off. | The default value for default |
P0123 | The high level of gas pedal position sensor signal | Off. | The default value for default |
P0218 | Oil temperature too high | Off. | Sample control at excess temperature. Holds 4 transfer. Torque converter lock ban. Disables adaptation gear. |
P0562 | Low voltage control unit | Off. | Prohibition on blocking the torque converter. DNA |
P0602 | The control unit is not programmed | ON. | Remains in neutral |
P0610 | Additional hardware error car with power control | ON. | The data are used calibration of the TID (A) |
P0613 | Processor error control unit | Off. | All solenoids are turned off |
P0614 | Data incompatibility ECM and TCM for adjusting the moment the engine | ON. | Only neutral, back and second gear. Ban converter clutch switch adaption is off |
P0634 | Temperature control unit exceeded | ON. | DNS, SOL OFF, actively hydraulic control. |
P063E | There is no signal input on the situation of throttle, when flap auto definition | ON. | The default value for default |
P063F | There is no coolant temperature signal of Auto determination | Off. | – |
P0657 | The gap chain Patients | ON. | SOL OFF DNA. Ban torque converter lock, barring the master modulation. |
P0658 | Low voltage in the circuit of Patients | ON. | DNS, SOL OFF hydraulic control active |
P0659 | High voltage in the circuit of Patients | ON. | DNS, SOL OFF hydraulic control active |
P0702 | The control unit does not recognize AUTOMATIC configuration | ON. | Uses standard configuration |
P0703 | There is a problem with the brake sensor | Off. | On truck it is impossible to Enable N-D, If the code is active, the work is prohibited retarder. |
P0708 | High level signal from the current transfer. | ON | Ignores the signal |
P070C | Low oil level sensor signal | Off. | – |
P070D | High level oil level sensor signal | Off. | – |
P0711 | Adjunct oil temperature sensor signal | ON. | Uses the value of the the default temperature |
P0712 | Low oil temperature sensor signal | ON. | Uses standard the temperature value |
P0713 | The high level of oil temperature sensor signal | ON. | Uses standard the temperature value |
P0716 | Adjunct of the turbine wheel speed sensor signal | ON. | DNS, the AUTOMATIC TRANSMISSION is blocked on the current transfer |
Comments